Panasonic HDC-SD100PC User Manual

VQT1T64

∫ Charging the battery

1) Connect the AC cable to the AC adaptor and 

the AC outlet.

2) Insert the battery into the battery charger by 

aligning the arrows.

∫ Inserting the battery

Install the battery by inserting it in the direction 
shown in the figure.

A Insert the battery until it clicks and locks.

∫ How to turn on the power

Turn on the power by turning the mode dial to 

 or 

 while pressing the lock release 

button A.

≥ Rotate the mode dial while at the same time 

pressing in the lock release button if changing 
from OFF to another mode.

≥ Status indicator B
≥ Align with the mark C.
≥ To turn off the power, set the mode dial to OFF.

∫ Inserting/removing an SD card

1) Open the LCD monitor.
≥ Check that the card access lamp has gone off.
2) Open the SD card cover by sliding the OPEN 

lever B.

3) Insert/remove the SD card.
≥ When inserting an SD card, face the label side 

C in the direction shown in the illustration and 
press it straight in as far as it will go.

≥ When removing the SD card, press the center 

of the SD card and then pull it straight out.

4) Securely close the SD card cover.
≥ Securely close it until it clicks.

Charging lamp 
[CHARGE] A

Lights up:
Charging
Goes off:
Charging 
completed

Card access lamp [ACCESS] A
≥ When this unit is accessing the card, the 

access lamp lights up.

HDCSD100P-VQT1T64_ENG.book  12 ページ  ２００８年７月１４日　月曜日　午後８時２分