Panasonic AG-HPX170P User Manual

(Camera)

Formats the SD memory cards.

(Camera)

(MCR)

Loads the settings in a previously stored user file.
SAVE: 

Saves the updated user file settings.
INITIAL: 

Returns the user settings in the user file to the factory settings.

After a LOAD or INITIAL operation, turn the POWER switch off and 

then back on again to make the new settings available.

An INITIAL operation does not change the TIME ZONE settings 

(Page 111).

•

(Camera)

(MCR)

Sets the operations of the supplied remote control unit. (Remote control 

setup. (Page 18))
OFF: 

Operations are not accepted from any remote control.
1: 

Accepts commands from the remote control set for “operation mode 1”.
: 

Accepts commands from the remote control set for “operation mode 2”.

(Camera)

Sets the control method for backup recording using a backup unit 

connected to the 1394 terminal.
OFF: 

The backup unit is not controlled.
EXT: 

The backup unit can be controlled by the START/STOP button. The 

images shot by the camera recorder are recorded by the backup unit. 

Note that the camera recorder does not record them.
BOTH: 

The images shot by the camera recorder are recorded by both the 

camera recorder and backup unit.
CHAIN: 

When the camera recorder’s media approaches its end during 

shooting, the backup unit in the recording stand-by mode automatically 

starts recording images.

(Camera)

Sets how the START/STOP button works for the backup unit.
REC_P: 

This switches between recording and pause.
STOP: 

This switches between recording and stop.
<Note>

If the backup unit does not have a rec pause function, select STOP.

(Camera)

(MCR)

Selects the terminal for data transfer. (You cannot select USB and 1394 

at the same time.)
USB DEVICE: 

Mode for sending files using the USB connector.
19 DEVICE: 

Mode for sending files using the 1394 connector.
19 HOST: 

Mode for copying files from the P2 card onto an external hard disk drive 

using the 1394 connector.

___indicates the factory setting.