3com iCV-01a User Manual

Note: 
Check that you have setup valid Email / FTP accounts first before proceeding with 
the rest of the configuration. 
 
To setup Email / FTP, see Section 2.4.4 

 

 

Detection Sensitivity 

This will determines the level of change before motion capture is triggered.    A 
high percentage means a small change will trigger motion capture. 

 

Send image every … second(s) 

Select either; 0.5, 1, 2, 3, 4 or 5 seconds. 

 

Stop sending after … email(s) or image idle for … second(s) 

WebCAM will stop sending emails on the lower of the two conditions.  The 
Administrator can set between 1, 3, 5, 7 and 10 seconds.    Emails can be set 
from 1 to 99999 pieces or 0 for stop sending email only when image idle 
occurred. 

 

When the unit is set to On Schedule, the Administrator can configure the four 
preferred schedule time slots for motion detection.  Time must be entered in 
24hr format. 

 

Send to FTP Server 

Click  Yes to activate.    This option allows the administrator to send and store 
the motion detected images on a FTP site.    This is useful for future reference 
and recording purpose. 

 

ftp://<empty>/<folder> 

This allows the Administrator to determine the folder where the Motion Detected 
files are stored.    Enter a folder name in <folder>.  Click Apply when done. 

Note:  
The folder name must be valid and has appropriate upload permissions. 
 
You must first enter a valid FTP address in Email / FTP page.    Otherwise the ftp 
address field will be left <empty>. 
 
To setup the FTP server, see Section 2.4.4 

 

 

The administrator can also determine to either have the system automatically 
assign the filenames for the pictures saved.    Or manually assign the filename. 

 

Specify a prefix filename for the motion detected JPG images.  The default 
prefix is image_