3com iCV-01a User Manual

Choose this if you want your Router to assign an IP address to WebCAM.    This is 
the default setting. 

 

Choose this if you want to allow WebCAM to obtain an IP address using Bootp 
protocol. 

 

Choose this if you want to assign a fix IP address, Subnet Mask and Gateway for 
WebCAM.    (Refer to Appendix C for explanation on IP Addresses) 

 

This section sets security password against unauthorised access to devices through 
this Utility. 

 

Fig.59  IP Configuration: Advanced settings

 

 

Use this to set an access password to WebCAM Utility.  Once set, the IP 
Address will not be shown on the right display panel (see below). 

 

 

Device Password can only be set for WebCAM from within the same LAN by an 
Administrator.