Sharp DSR-PD150P User Manual

Your camcorder is supplied with a vanadium-lithium battery installed so as to retain
the date and time, etc., regardless of the setting of the POWER switch. The vanadium-
lithium battery is always charged as long as you are using your camcorder. The battery,
however, will get discharged gradually if you do not use your camcorder. It will be
completely discharged in about four months if you do not use your camcorder at all.
Even if the vanadium-lithium battery is not charged, it will not affect the camcorder
operation. To retain the date and time, etc., charge the battery if the battery is
discharged.

Charging the vanadium-lithium battery:
•Connect your camcorder to mains using the AC power adaptor supplied with your

camcorder, and leave your camcorder with the POWER switch turned off for more
than 24 hours.

•Or install the fully charged battery pack in your camcorder, and leave your camcorder

with the POWER switch turned off for more than 24 hours.

•Operate your camcorder on 7.2 V (battery pack) or 8.4 V (AC power adaptor).
•For DC or AC operation, use the accessories recommended in this operating

instructions.

•If any solid object or liquid get inside the casing, unplug your camcorder and have it

checked by a Sony dealer before operating it any further.

•Avoid rough handling or mechanical shock. Be particularly careful of the lens.
•Keep the POWER switch set to OFF (CHG) when you are not using your camcorder.
•Do not wrap your camcorder with a towel, for example, and operate it. Doing so

might cause heat to build up inside.

•Keep your camcorder away from strong magnetic fields or mechanical vibration.

Noise may appear on the image.

•Do not touch the LCD screen with a sharp-pointed object.
•If your camcorder is used in a cold place, a residual image may appear on the LCD

screen. This is not a malfunction.

•While using your camcorder, the back of the LCD screen may heat up. This is not a

malfunction.

•Do not insert anything into the small holes on the rear of the cassette. These holes are

used to sense the type and thickness of the tape and if the recording tab is in or out.

•Do not open the tape protect cover or touch the tape.
•Avoid touching or damaging the terminals. To remove dust, clean the terminals with

a soft cloth.

•Remove the tape, and periodically turn on the power, operate the CAMERA and VCR

sections and play back a tape for about three minutes when your camcorder is not to
be used for a long time.

•Clean the lens with a soft brush to remove dust. If there are fingerprints on the lens,

remove them with a soft cloth.

•Clean the camcorder body with a dry soft cloth, or a soft cloth lightly moistened with

a mild detergent solution. Do not use any type of solvent which may damage the
finish.