Sony DVW-790WS/790WSP User Manual

1-8

DVW-790WS/709WS/707

DVW-790WSP/709WSP/707P P2V1

The three flexible card wires are used in the connection of
the MB-810 board and the TC-101 board.
Be careful not to bend forcedly these flexible card wires.
Crease of wire can seriously shorten its life.

n
Turn off the power, and then unplug the power cord or
remove the battery before disconnecting/reconnecting the
wires.

1.

Slide portions A in the direction of the arrow to unlock
the connector, and then pull the flexible card wire out.

1.

Check to see that the conductive surface (silver side)
of the flexible card wire is not soiled with dust.

2.

Slide portions A in the direction of the arrow, and then
insert the flexible card wire into the connector with the
conductive surface (silver side) down.
n
Be sure to insert the wire straightforward.

3.

Slide portions A in the reverse direction to lock the
connector.

w
The IC link is critical for safe operation.

To avoid danger of a fire or electric shock, be sure use the

specified component as a spare part when replacing it.

c
Replacement of the IC link of the plugged-in unit may be

hazardous.

Be sure to turn off the power, and then unplug the cord

from the DC IN connector before replacing the IC link.

An IC link is mounted on the B side of the HP-93 board.

This will blow when the overcurrent flows because of

internal circuit failure. If it blows, check the circuit for

overcurrent after turning off the power.

And then, replace the IC link with specified part.

HP-93

F1

IC Link 2A

1-533-282-21

1-3. Disconnecting/Reconnecting Flexible Card Wires
1-4. IC Link

Flexible card wire

Slide portions A

flexible card wire