Sony DVW-790WS/790WSP User Manual
3-24
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
3-5. Replacing the DC Fans
3-5-2. Lower DC Fan
1.
Open the inside panel.
n
If the optional DIF-75 board (BKDW-702)
has been installed, disconnect the coaxial
cable from the connector (CN2) on the
n
If the optional DIF-75 board (BKDW-702)
has been installed, disconnect the coaxial
cable from the connector (CN2) on the
DIF-75 board. And then pull the DIF-75
board out.
board out.
2.
Remove the three screws (P 2
x4.5) to
remove the spacer.
3.
Remove the two screws (P 2.6
x16) to
remove the DC fan, cushion, and nut plate.
n
The cushion is not used in the following
serial numbers and higher.
DVW-707 :
n
The cushion is not used in the following
serial numbers and higher.
DVW-707 :
10031 and higher
DVW-707P :
40071 and higher
DVW-709WS : 10046 and higher
DVW-709WSP : 40121 and higher
DVW-790WS : 10036 and higher
DVW-790WSP : 40126 and higher
4.
Disconnect the harness from the connector
(CN54) on the MB-811 board.
5.
Reattach the DC fan by reversing the remov-
ing steps.
Standard tightening torque :
8
x 10
_2
N
.m {0.8 kgf.cm}
n
Take care that the harness does not touch the
Take care that the harness does not touch the
fan’s blade and is not routed across the fan.
COPAL
F251R
Nut plate
DC fan
P 2.6
x
16
Cushion
Spacer
MB-811 board
CN54
P 2
x
4.5
Direction of the fan
when attached
when attached