Sony DVW-709WS/709WSP User Manual
4-2
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
Pinch roller
Capstan shaft
T slider
Pin
Catcher T
V cut
T2 guide
T1 guide
Drum
S1 guide
S2 guide
Catcher S
V cut
S slider
Pin
S3 guide
S5 guide
Tension regulator
4-1-2. Threading End/Unthreading
End Mode
1. Threading End Mode
Threading end mode means that S and T sliders
move from around the reel tables to both sides of
move from around the reel tables to both sides of
the drum, and stop at the cut portions like a V of
catchers S and T.
catchers S and T.
Selection Procedures into the Threading
End Mode With a Tape
End Mode With a Tape
. Insert a cassette tape in the cassette compart-
ment.
. Close the front lid.
Selection Procedures into the Threading
End Mode Without a Tape
End Mode Without a Tape
. Place the cassette compartment into the down state.
(When the cassette compartment does not attach
to the unit, interrupt the cassette compartment
lock switch (photo interrupter) on the SE board
using a black paper or equivalent.)
. Press the cassette in switch about 1 second in this
state while pressing the four switches of the sen-
sor (A).
2. Unthreading End Mode
Unthreading end mode means that the S and T slid-
ers move from the catchers S and T to the direc-
tions of the reel tables, and stop.
The unthreading end mode is the same as the ST/
The unthreading end mode is the same as the ST/
BY mode.
If selecting the unit into this mode, the cassette
compartment will raise up.
If selecting the unit into this mode, the cassette
compartment will raise up.
Selection Procedure into the Unthreading
End Mode
End Mode
Press the EJECT button.
Cassette in switch
Black paper or
equivalent
equivalent
Photo interrupter
(cassette compartment lock switch)
(cassette compartment lock switch)
Switches of sensor (A)
Switches of sensor (A)
4-1. General Information for Parts Replacement and Adjustment