Sony HDR-HC5 Manual

Page of 131
80
• Cover the sensor of your VCR with black 
paper.
The power abruptly turns off.
• When approximately 5 minutes have 
elapsed while you do not operate your 
camcorder, the camcorder is automatically 
turned off (A.SHUT OFF). Change the 
setting of [A.SHUT OFF] (p. 62), or turn 
on the power again (p. 17), or use the AC 
Adaptor.
• Charge the battery pack (p. 14).
The  /CHG (charge) lamp does not 
light while the battery pack is being 
charged.
• Slide the POWER switch to OFF (CHG) 
• Attach the battery pack to the camcorder 
correctly (p. 14).
• Connect the power cord to the wall outlet 
properly.
• The battery charge is completed (p. 14).
The  /CHG (charge) lamp flashes 
while the battery pack is being 
charged.
• Attach the battery pack to the camcorder 
correctly (p. 14). If the problem persists, 
disconnect the AC Adaptor from the wall 
outlet and contact your Sony dealer. The 
battery pack may be damaged.
The remaining battery time indicator 
does not indicate the correct time.
• Ambient temperature is too high or too low, 
or the battery pack has not been charged 
enough. This is not a malfunction.
• Fully charge the battery again. If the 
problem persists, the battery may be worn-
out. Replace it with a new one (p. 14, 95).
• The indicated time may not be correct in 
certain circumstances. For example, when 
you open or close the LCD panel, it takes 
about 1 minute to display the correct 
remaining battery time.
The battery pack discharges too 
quickly.
• Ambient temperature is too high or low, or 
the battery pack has not been charged 
enough. This is not a malfunction.
• Fully charge the battery again. If the 
problem persists, the battery may be worn-
out. Replace it with a new one (p. 14, 95).
You cannot turn the LCD backlight 
off.
• During Easy Handycam operation, you 
cannot turn the LCD backlight on/off by 
pressing and holding DISPLAY/BATT 
INFO (p. 23).
You cannot turn off the indicator.
• You cannot turn off 
. Touch 
 to 
check the warning messages (p. 89).
The buttons do not appear on the 
touch panel.
• Touch the LCD screen lightly.
• Press DISPLAY/BATT INFO on your 
camcorder (or DISPLAY on the Remote 
Commander) (p. 19, 108).
The buttons on the touch panel do 
not work correctly or do not work at 
all.
• Adjust the touch panel ([CALIBRATION]) 
Menu items are grayed out.
• You cannot select grayed items in the 
current recording/playback situation.
• Depending on the functions, you may not 
be able to use them together (p. 86).
Batteries/Power sources
LCD screen/viewfinder
Troubleshooting (Continued)