Sony DXC-D35 User Manual

2-5

DXC-D35/D35WS(UC)

DXC-D35P/D35WSP(CE) V1

Front unit assembly

Screws
with washer
(B3 

x

 10)

Screws
with washer
(B3 

x

 10)

5.

Remove the four screws to remove the front unit
assembly.

6.

Remove the setscrew shown in the figure and take off

the filter knob.

7.

Remove the four screws and four washers of the front

panel to remove the CCD unit.
n
Use great care to avoid any pressure on the PA board

when handling the CCD unit.

Every CCD unit has its own ID number called CCD block
number. It shown the CCD block type and serial number
for the CCD block.

The CCD block number label is put in the CCD unit.

GUA xxxxx : DXC-D35 (NTSC)
GVA xxxxx : DXC-D35P (PAL)
HDA xxxxx : DXC-D35WS (NTSC)
HEA xxxxx : DXC-D35WSP (PAL)

Serial number for the CCD unit
CCD block type

1.

Remove the lens and viewfinder. (Refer to the instruc-
tion manual.)
n
To protect the prism block, be sure to cover the lens

mount portion with the mount cap.

2.

Remove the left side plate. (Refer to Section 2-2-1.)

3.

Remove the AT board. (Refer to Section 2-2-2.)

4.

Disconnect the harness connectors from the four

connectors (CN2, CN105, CN106 and CN107) and the

flexible card wire from the connector (CN103) on the

MB board.
n
When disconnecting the flexible card wire, refer to

Section 2-11.

CN105

CN106

CN107

CN123

CN103

CN2

MB board

Washer (SW3)

Washers (SW3)

Screws (B3 

x

 8)

Screw (B3 

x

 8)

Setscrew (3 

x

 4)

Front panel

Filter knob

CCD unit

2-3. Replacement of CCD Unit