Sony HDR-AS30 User Manual
Ta
bl
bl
O
Se
ttin
g
ttin
g
Inde
67
GB
Precautions
Do not use/store the camera in the following places
• In an extremely hot, cold or humid place
In places such as in a car parked in the sun, the camera body may become deformed and this may cause a
malfunction.
malfunction.
• Under direct sunlight or near a heater are not suitable places for storage.
The camera body may become discolored or deformed, and this may cause a malfunction.
• In a location subject to strong vibration
• Near strong magnetic fields
• In sandy or dusty places
• Near strong magnetic fields
• In sandy or dusty places
Be careful not to let sand or dust get into the camera. This may cause the camera to malfunction, and in
some cases may be irreparable.
some cases may be irreparable.
On carrying
Do not sit down in a chair or other place with the camera in the back pocket of your trousers or skirt, as this
may cause malfunction or damage the camera.
may cause malfunction or damage the camera.
Care and storage of the lens
• Wipe the surface of the lens clean with a soft cloth in the following instances:
– When there are fingerprints on the lens surface.
– In hot or humid locations
– When the lens is exposed to salty air such as at the seaside.
– In hot or humid locations
– When the lens is exposed to salty air such as at the seaside.
• Store in a well-ventilated location subject to little dirt or dust.
• To prevent mold, periodically clean the lens as described above.
• To prevent mold, periodically clean the lens as described above.
On cleaning
Clean the camera surface with a soft cloth slightly moistened with water, then wipe the surface with a dry
cloth. Do not use any of the following as they may damage the finish or the casing.
– Chemical products such as thinner, benzine, alcohol, disposable cloths, insect repellent, sunscreen or
cloth. Do not use any of the following as they may damage the finish or the casing.
– Chemical products such as thinner, benzine, alcohol, disposable cloths, insect repellent, sunscreen or
insecticide, etc.
– Do not touch the camera with any of the above on your hand.
– Do not leave the camera in contact with rubber or vinyl for a long time.
– Do not leave the camera in contact with rubber or vinyl for a long time.
On operating temperatures
The camera is designed for use in temperatures between 0°C and 40°C (32°F and 104°F). Shooting in
extremely cold or hot places that exceed this range is not recommended.
extremely cold or hot places that exceed this range is not recommended.
On moisture condensation
If the camera is brought directly from a cold to a warm location, moisture may condense inside or outside
the camera. This moisture condensation may cause a malfunction of the camera.
the camera. This moisture condensation may cause a malfunction of the camera.
If moisture condensation occurs
Turn off the camera and wait about 1 hour for the moisture to evaporate.
Note on moisture condensation
Moisture may condense when you bring the camera from a cold place into a warm place (or vice versa) or
when you use the camera in a humid place as shown below.
– When you bring the camera from a ski slope into a warm place.
– When you bring the camera from an air conditioned car or room into a hot place outside.
– When you use the camera after a squall or a shower.
– When you use the camera in a hot and humid place.
when you use the camera in a humid place as shown below.
– When you bring the camera from a ski slope into a warm place.
– When you bring the camera from an air conditioned car or room into a hot place outside.
– When you use the camera after a squall or a shower.
– When you use the camera in a hot and humid place.
Continued
r