Sony DSR-400K User Manual

37

Connecting the Remote Control Unit (DSR-450WS/450WSP only)

  Ch

ap
te

r 2
  Pr

ep
ar

a

tio
n

Connect the tuner power cord to the DC OUT 
connector of the camcorder, and the audio output cable 
to the AUDIO IN CH-1 or CH-2 connector.

Set the switches as below.

• Set the AUDIO IN input selection switch to MIC for 

the channel to which the audio out cable is 
connected.

• Set the AUDIO IN (CH-1/CH-2) switch for the 

channel to which the audio output cable is connected 
to REAR.

Connect an audio mixer or other external audio system 
component to the AUDIO IN CH-1/CH-2 connector as 
shown below.

Set the AUDIO IN input selection switch to LINE for 
the channel to which the external audio equipment is 
connected.

Selection of the recording audio input
Set the AUDIO IN (CH-1/CH-2) switch to REAR for the 
channel to which the external audio equipment is 
connected.
If you record and adjust both channel 1 and 2, set both 
AUDIO IN (CH-1/CH-2) switches to REAR.

 

Connecting the RM-B150/B750 Remote Control Unit 
enables remote control of the principal camera and VTR 
functions.
Connecting the remote control unit to the REMOTE 
connector (8-pin) automatically puts the camcorder into 
remote control mode. If you disconnect the remote control 
unit, the remote control mode is cancelled.

The following switches on the camcorder do not function.
• GAIN switch
• OUTPUT/DCC switch
• WHITE BAL switch
• AUTO W/B BAL switch
• SHUTTER switch
• REC button (the VTR button on the lens and the 

ASSIGN switch to which the REC SWITCH function is 
assigned) when the RM REC START item is set to RM 
on the FUNCTION 3 page of the MAINTENANCE 
menu.

The settings of the paint adjustment that were in effect the 
last time the remote control unit was used are recalled.

To audio mixer, etc.

AUDIO IN (CH-1/CH-2) switches: 
Set to REAR.

AUDIO IN CH-1/CH-2 
connectors

AUDIO IN input selection switch: 
Set to LINE.

RM-B150/B750

Remote 
connector

Remote control cable