Sony 2-887-515-14(1) User Manual

Page of 127
109
G:\SONY\PV\CX18500_GB_kaihan\2887515141\2887515141HDRFX7E\01GB11ADD.fm
HDR-FX7E
2-887-515-14(1)
Additional Infor
m
ation
x
Note on moisture condensation
Moisture may condense when you bring 
your camcorder from a cold place into a 
warm place (or vice versa) or when you use 
your camcorder in a humid place as shown 
below.
• When you bring your camcorder from a ski 
slope into a place warmed up by a heating 
device.
• When you bring your camcorder from an air 
conditioned car or room into a hot place outside.
• When you use your camcorder after a squall or a 
shower.
• When you use your camcorder in a hot and 
humid place.
x
How to avoid moisture condensation
When you bring your camcorder from a 
cold place into a warm place, put your 
camcorder in a plastic bag and seal it 
tightly. Remove the bag when the air 
temperature inside the plastic bag has 
reached the surrounding temperature (after 
about one hour).
Video head
If you play back a tape recorded in HDV 
format, the image and sound may freeze for 
a while (about 0.5 seconds). 
This occurs if the HDV signals cannot be 
recorded or played back correctly because 
of dirt on the tape or video head. Depending 
on the cassette, this fairly infrequently 
occurs even if the cassette is brand new or 
is not used a lot.
If this freezing point is created while 
playing back, you can solve this problem 
and see the pictures by rewinding after 
slightly forwarding. Such a freezing point 
cannot be recovered if it was created while 
recording.
To prevent such a problem, use the Sony 
mini DV cassette.
• If the following problem occurs, clean the video 
heads for 10 seconds with a cleaning cassette 
(optional).
– Playback pictures do not move.
– Playback pictures do not appear.
– The sound breaks off.
– [x
 Dirty video head. Use a cleaning 
cassette.] appears on the screen during 
recording.
– The following phenomenon occurs in HDV 
format.
– The following phenomenon occurs in DV 
format.
• The video heads will be worn after long use. If 
you cannot obtain a clear image even after using 
a cleaning cassette (optional), the video heads 
may be worn out. Please contact your Sony 
dealer or local authorized Sony service facility 
to have the video heads replaced.
LCD screen
• Do not exert excessive pressure on the LCD 
screen, as it may cause damage.
• If your camcorder is used in a cold place, a 
residual image may appear on the LCD screen. 
This is not a malfunction.
• While using your camcorder, the back of the 
LCD screen may heat up. This is not a 
malfunction.
The playback 
screen pauses.
The playback screen 
goes blank.
(Solid blue screen)
Block-noise 
appears.
The playback screen goes blank.
(Solid blue screen)
Continued 
,