Sony 510P User Manual

Chap

te

r 

9

   Set

ting Up th

e Camc

orde

r

155

9-5 Audio Input System

Open the CAC-12 and remove the microphone 
adaptor.

1) Attach the microphone adaptor when using a small-diameter external 

microphone.

Place an electret condenser microphone in the CAC-
12.

Connect the microphone cable to the AUDIO IN CH1 
or AUDIO IN CH2 connector. Set the switches as 
described in the section “Switch settings when using 
an external microphone” (see page 154).

When you detach the CAC-12 Microphone Holder 
once you have attached to the camcorder, be careful 
not to lose the two screws fixing the CAC-12. After 
detaching the CAC-12, be sure to put the two screws 
back into their original places (see the figure 
illustrating the step 

1 operation).

To use a Sony UHF wireless microphone system, fit one of 
the following UHF portable tuners. 
• WRR-855A/855B UHF Synthesized Tuner Unit
• WRR-862 UHF Portable Tuner.

For each of these UHF portable tuners, use the following 
attachment procedure.

You can use the WRR-855A/855B UHF Synthesized 
Tuner Unit simply by inserting it into the slot in the 
camcorder, and fastening the fixing screws.

Undo the four fixing screws holding the cover of the 
slot, and remove the cover.

Insert the WRR-855A/855B, and fasten the four fixing 
screws.

Screws removed 
in step 1

CAC-12

Open the CAC-12.

Microphone 
adaptor 

1)

Loosen the screw.

Close the CAC-12.

m

Tighten the screw.

ECM-672 or 
similar 
microphone