Panasonic BDP-140 User Manual

En

A message other than 
“Networks is OK.” is 
displayed when 

Test is performed.

Is “Network is FAILED.” 
displayed?

• Check that this player and the Ethernet hub (or router with a hub 
functionality) are properly connected.

• If the IP address is obtained using the DHCP server function, check 
the setting is correct at the 

Information (page 41). For details on the 

DHCP server function, see the operating instructions for the Ethernet 
hub (or router with a hub functionality).

• Set the IP address manually.

• Check the operation and settings of the DHCP server function of the 
Ethernet hub (or router with hub functionality). For details on the DHCP 
server function, see the operating instructions for the Ethernet hub (or 
router with a hub functionality).

• If this player has been set manually, reset the IP address of this player 
or other components.

Is the Ethernet hub (or router 
with a hub functionality) 
operating properly?

• Check the settings and operation the Ethernet hub (or router with a 
hub functionality). For details, see the operating instructions for the 
Ethernet hub.

• Reboot the Ethernet hub (or router with a hub functionality).

The player’s power turns off 
automatically.

Is 

Auto Power Off set to 10 

min/20 min/30 min?

If 

Auto Power Off is set to 10 min/20 min/30 min, the player’s power 

turns off automatically if no operation is performed for over 30 minutes 
(page 43).

The player’s power turns on 
automatically.

Is 

Control set to On?

The player’s power may turn on together with the power of the TV 
connected to the 

HDMI OUT terminal. If you do not want the player’s 

power to turn on when the TV’s power is turned on, set 

Control to Off 

(page 41).

The player cannot be 
operated with the remote 
control.

Are you operating the remote 
control from a point too far 
away from the player?

Operate from within 7 m of the remote control sensor.

Are the batteries dead?

Replace the batteries (page 5).

Input of the connected TV 
and AV system switches 
automatically.

Is 

Control set to On?

The input of the TV and AV system (AV receiver or amplifier, etc.) 
connected to the 

HDMI OUT terminal may automatically switch to the 

player when playback starts on the player or the menu screen (Home 
Media Gallery, etc.) is displayed. If you do not want the inputs of the 
connected TV and AV system (AV receiver or amplifier, etc.) to switch 
automatically, set 

Control to Off (page 41).

Settings I have made have 
been cleared.

• Have you disconnected the 
power cord while the player’s 
power was on?

• Has there been a power 
failure?

Always press 

 STANDBY/ON on the player’s front panel or 

 STANDBY/ON on the remote control and check that POWER OFF 
has turned off from the player’s front panel display before 
disconnecting the power cord. Be particularly careful when the power 
cord is connected to the AC outlet on another device because the 
player turns off in conjunction with the device.

BDP-140_VXCN5_IBD_EN.book  Page 59  Wednesday, September 28, 2011  9:52 AM