Sherwood BDP-904 User Manual
E
N
G
L
IS
H
34
E
N
G
L
IS
H
SETTING THE NETWORK
Then the IP Settings menu will be displayed as follows :
1.
Perform the steps 1 and 2 in “System Settings”
procedure on page 28 to select the Network.
3.
Press the CURSOR RIGHT button to display the
IP Mode.
4.
Press the CURSOR UP/DOWN buttons to select
the desired IP Mode, then press the OK button.
2.
Press the CURSOR UP/DOWN buttons to select
the network configuration mode, then press the
OK button.
OK button.
• Then the network setting menu will be displayed.
Wired :
Configures network settings depending on your internet
environment, etc. when connecting to the internet.
Network Test :
Detects the internet connection and automatically
configures the network settings by the DHCP server
function of the router or modem.
Configures network settings depending on your internet
environment, etc. when connecting to the internet.
Network Test :
Detects the internet connection and automatically
configures the network settings by the DHCP server
function of the router or modem.
■Note :
• When IP Mode is set to Off, Network Test cannot be
• When IP Mode is set to Off, Network Test cannot be
selected.
Off:
Disables this unit’s LAN capabilities.
Manual :
Configures network settings manually.
Dynamic (default setting) :
Automatically configures the network settings by the DHCP
server function of the router or modem.
Disables this unit’s LAN capabilities.
Manual :
Configures network settings manually.
Dynamic (default setting) :
Automatically configures the network settings by the DHCP
server function of the router or modem.
■Note :
• Select the Manual only when the DHCP server function of
• Select the Manual only when the DHCP server function of
the router or modem cannot be used for the automatic
configuration.
configuration.
■When selecting the Manual
• You can select IP Address, Subnet Mask, Gateway,
• You can select IP Address, Subnet Mask, Gateway,
Primary DNS and Secondary DNS to configure them
manually.
manually.
• On the IP Settings menu, “Link Status” and “Mac
Address” display the corresponding information merely.
① Press the CURSOR UP/DOWN buttons to select the
desired option, then press the OK button.
Then the New Value entry screen will be displayed.
Then the New Value entry screen will be displayed.
Example : When selecting IP Address
② Enter the new value pressing the NUMERIC buttons,
then press the CURSOR buttons to select “OK” and
press the OK button.
press the OK button.
③ Repeat the above steps ① and ② until other new
values are all entered.
• To access BD-LIVE contents from websites, you should connect this unit to the internet and set the communication settings.
(For details, “CONNECTING TO NETWORK” on page 8.)
• When you set the communication setting manually, the following information of the connected router or modem is required.
Confirm the information prior to the setting : IP address, Subnet mask, Gateway, Primary DNS and Secondary DNS.
When selecting the Wired
MAC Address
Link Status
IP Settings
IP Mode
Apply
Cancel
Link Up
Dynamic
00:23:03:00:50:b4
IP Address
192.168.1.110
Subnet Mask
255.255.255.0
Gateway
192.168.1.1
Primary DNS
168.126.63.1
Secondary DNS 0. 0. 0. 0
Please enter a new IP Address.
Valid range of each segment is 0 to 255.
Current value 192.168.1.110
New Value
.
.
.
OK
Cancel
• When selecting the Network Test, see page 35.
BDP-904(A)_091204:BDP-904(A) 2009-12-07 오후 2:17 페이지 34