Sharp 10P01-CH-NG User Manual

Hold in the tab on the battery cover and pull the 
cover towards the direction of the arrow.

Load the two “AA” size batteries (R-06 size, 
UM/SUM-3). Place batteries with their terminals 
corresponding to the m and n indications in 
battery compartment.

Insert the smaller tab of the battery cover into 
the opening 

1, and press down on the cover 

until it clicks in place 

2.

 

Do not subject the remote control unit to shock, water or 
excessive humidity.
The remote control unit may not function if the Player's 
remote sensor is in direct sunlight or any other strong light.
Incorrect use of batteries may cause them to leak or burst. 
Read the battery warnings and use the batteries properly.
Do not mix old and new batteries, or mix different brands.
Remove the batteries if you will not use the remote control 
unit for an extended period of time.

•

•

•

•
•

Do not use or store batteries in direct sunlight or other 
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or 
catch fire.
It can also reduce the life or performance of batteries.

•

Plug the supplied AC cord into the AC IN terminal on 
the rear of the Player. Then plug into AC outlet.

 

Place the Player close to the AC outlet, and keep the 
power plug within reach.
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT 
TOUCH THE UN-INSULATED PARTS OF ANY CABLES 
WHILE THE AC CORD IS CONNECTED.
The ON/STANDBY indicator blinks while the Player is 
preparing for starting up. You cannot turn the Player on 
until the ON/STANDBY indicator stops blinking.
If you are not going to use this Player for a long period of 
time, be sure to remove the AC cord from the AC outlet.

•

•

•

•

Playback

Remote control sensor

Remote control unit

30º

30º

7 m

To AC IN terminal

To AC outlet