Cateye MSC-2DX N Leaflet

Attach the magnet 

9

 temporarily to the right

side spoke of the front wheel.

Attach the sensor 

2

 temporarily to the inside of the right front fork.

Adjust the position of the sensor 

2

 and the magnet 

9

 so that it

meets the conditions 

 and 

 in the “Important” column.  Fas-

ten them tightly.
Reference: If the clearance between the speed sensor and the

magnet is wide, mount the sensor band 

34

 in an

opposite way as shown.
In case of aerofork, apply the attachment 

0

.

Secure the wire along the front fork using the ny-
lon ties 

5

 and wind it round the brake cable up to

handlebar.
Note:

Use the rubber pad 

6

 or band holder pad 

7

 so

that the bracket’s band 

1

 fits your handlebar.  Fix

it with the screw.
Reference: To release the band, pull it while

pushing the area marked with 

.

Make sure that the following parts are included in the package.

1

Bracket (with 2Dx attachment)

2

Sensor

3

Sensor Band-A (L/S)

4

Sensor Band-B

5

Nylon Tie

2Dx attachment

9

2

9

2

9

4

3

2

8

6

front fork

3

4

0

1

6

7

5

1

5

6

Rubber Pad

7

Band Holder Pad

8

Screw

9

Magnet

0

Attachment for Aerofork

The clearance between the sensor 

2

 and the mag-

net 

9

 should be about 5mm.

Align center of the magnet 

9

 and the marking line of

the sensor 

2

 while rotating the front wheel.

about 5mm

marking line

spoke

press

pull

Copyright© 2001 CAT EYE Co.,Ltd.

MSC2DxMM-010604 

 Printed in Japan

066600120