Husqvarna TE 125 EU User Manual
12 SERVICE WORK ON THE CHASSIS
46
101327-10
Main work
– Remove screws
1
on the left fork leg. Lift off the fork protector.
– Remove the screws on the right fork leg. Lift off the fork protector.
12.10
Installing the fork protector
x
101327-10
Main work
– Position the fork protection on the left fork leg. Mount and tighten screws
1
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
– Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
Finishing work
– Install the fork legs.
x
– Install the front wheel.
– Install the headlight mask with the headlight. ( p. 83)
– Check the headlight setting. ( p. 84)
– Check the headlight setting. ( p. 84)
12.11
Removing the lower triple clamp
x
Preparatory work
– Switch off all power consumers and switch off the engine.
– Remove the headlight mask with the headlight. ( p. 82)
– Raise the motorcycle with the lift stand. ( p. 43)
– Remove the front wheel.
– Remove the headlight mask with the headlight. ( p. 82)
– Raise the motorcycle with the lift stand. ( p. 43)
– Remove the front wheel.
x
– Remove the fork legs.
x
– Remove the front fender. ( p. 49)
L01624-10
Main work
– Remove screw
1
. Remove screw
2
, take off the upper triple clamp with the han-
dlebar, and set it aside.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
L01623-10
– Remove O-ring
3
. Remove protective ring
4
.
– Take out the lower triple clamp with the steering stem.
– Take out the upper steering head bearing.
– Take out the upper steering head bearing.