Panasonic DMW-MCTZ3 User Manual

Page of 64
14
VQT1F25
Preparation
 -Checking the Case is Waterproof-
After setting the O-ring, check that no water leaks into the Case by 
submerging it in a water tank, bath tub etc. for more than about 
3 minutes before attaching a digital camera.
Do not use the Case in water over 40 °C/104 °F. The heat may damage the Case or 
cause water leakage.
Carry out the same test after attaching the digital camera to the Case. (P15)
∫ Notes
If bubbles rise from the Case when it is submerged in water or there is water inside 
the Case when you take it out the water, there is water leakage. In these cases, 
consult your dealer.
If water leaks into the Case while you are using it and the digital camera is 
submerged in water, remove the battery immediately. Hydrogen gas can cause 
burning or explosion if there is a fire nearby.
If you dive quickly while holding the Case or throw the Case from a ship into the sea, 
some water leakage may occur because of high pressure. This is not a malfunction 
of the Case. Always dive slowly into the water.
The Case is designed to be used at a depth of up to 40 m/130 feet. If you dive 
deeper than 40 m/130 feet, part of the Case may be damaged beyond repair.
When closing the Case, be careful that no foreign materials get caught between the 
O-ring and the O-ring groove. Even one strand of hair or one grain of sand can 
cause water leakage.
DMW-MCTZ3.book  14 ページ  2007年2月6日 火曜日 午後1時21分