Panasonic KX-TG2388 User Manual
Useful Information
For assistance, please visit http://www.panasonic.com/consumersupport
61
Troubleshooting
If the handset display shows error messages, see “If the Following Appear on Your
Display...” (p. 60) for the Cause & Remedy.
Display...” (p. 60) for the Cause & Remedy.
Problem
Cause & Remedy
“No link to base.
Move closer to
base, try again.” is
displayed and an alarm
tone sounds.
Move closer to
base, try again.” is
displayed and an alarm
tone sounds.
L
You are too far from the base unit. Walk closer to the
base unit.
base unit.
L
Confirm the base unit’s AC adaptor is plugged in.
L
Raise the base unit antenna.
L
If the above remedies do not solve the problem, the
handset may have lost communication with the base
unit. Register the handset again (page 45).
handset may have lost communication with the base
unit. Register the handset again (page 45).
Static, sound cuts in/out,
fades. Interference from
other electrical units.
fades. Interference from
other electrical units.
L
Move the handset and base unit away from other
electrical appliances.
electrical appliances.
L
Walk closer to the base unit.
L
Raise the base unit antenna.
L
If your unit is connected to a telephone line with DSL
service, we recommend connecting a noise filter
between the base unit and the telephone line jack.
Contact your DSL provider for details.
service, we recommend connecting a noise filter
between the base unit and the telephone line jack.
Contact your DSL provider for details.
The handset and/or base
unit does not ring.
unit does not ring.
L
The ringer volume is turned off. Set to high, medium, or
low (page 39).
low (page 39).
The handset display is
blank.
blank.
L
If the handset display is blank, fully charge the battery
(page 10).
(page 10).
You cannot program any
function items.
function items.
L
Programming is not possible while the handset and/or
base unit is being used.
base unit is being used.
L
Do not pause for over 60 seconds while programming.
L
Walk closer to the base unit.
L
While another user is listening to messages or the
Answering System is handling a call, you cannot
program. Try again later.
Answering System is handling a call, you cannot
program. Try again later.
While programming or
searching, the handset
starts to ring and the
program/search stops.
searching, the handset
starts to ring and the
program/search stops.
L
A call is coming in. To answer the call, press {C}, {s}
or {SP-PHONE}. Start again from the beginning after
hanging up.
or {SP-PHONE}. Start again from the beginning after
hanging up.
TG2388.book 61 ページ 2005年7月14日 木曜日 午後4時58分