Olympus 021 User Manual

Page of 37
E-16
E-15
Loading in the Case
Which digital cameras can be loaded?
This product (PT-021) is exclusively used for the CAMEDIA X-350.
Open the lens barrier.
The power is switched on when the lens barrier of the digital
camera is opened.
When the camera is left without any operation for at least three
minutes while the power is switched on, the camera will enter sleep
mode (standby) and the LCD will go out, and when another five
minutes pass without any operation, the lens will be retracted. In
such a case, cancel the sleep mode by operating any button.
Check the operation of the camera.
Confirm the operation according to the instruction manual for the digital
camera.
Load the digital camera.
• When the setting is insufficient, the loading of the
camera becomes imperfect and it may not be
possible to seal the Case or zooming may not
function. Insufficient sealing will cause water leakage.
CAUTION
Note
:
• At this time, the LCD should be left switched off to
save the battery.
Open the Case.
Insert the buckle opener of the accessory into the buckle opening
lever as shown in the figure (in direction 
①) Pull the buckle opener
slowly (in direction 
②). When not using the buckle opener, hold the
buckle opening lever with your thumb and index finger from the side
and pull it up slowly.
Quietly load the digital camera into the Case, taking care that the
projecting part of the zoom lever of the digital camera properly fits
into the recessed part of the zoom lever of the Case.
PT_021_JE.qxd  2004.3.8  7:10 PM  ページE-15