Olympus 048 User Manual
EN 27
En
Install the O-ring
Confirm that no foreign matter is adhered, apply a thin coat of the grease
provided to the O-ring, and fit the O-ring into the groove. At this point,
confirm that the O-ring does not stick out from the groove.
• When sealing this product, make sure that no hairs, fibers, sand
provided to the O-ring, and fit the O-ring into the groove. At this point,
confirm that the O-ring does not stick out from the groove.
• When sealing this product, make sure that no hairs, fibers, sand
particles or other foreign matter stick not only to the O-ring, but also to
the contact surface (front cover). Even a single hair or a single grain of
sand may cause water leakage. Please check with special care.
the contact surface (front cover). Even a single hair or a single grain of
sand may cause water leakage. Please check with special care.
Replace consumable parts
• The O-ring is a consumable part. Regardless of the number of times the
Case is used, it is recommended that the O-ring be replaced with a new
one at least once a year.
one at least once a year.
• Deterioration of the O-ring is accelerated by the use conditions and the
storage conditions. Replace the O-ring even before a year has passed
if it shows signs of damage, crack or loss of elasticity.
if it shows signs of damage, crack or loss of elasticity.
Examples of foreign matter sticking to the O-ring
Hair
Fibers
Grains of sand
Note:
• Please use genuine Olympus silicone grease, silica gel and O-ring.
• Do not try to replace the O-ring by yourself.
• We recommend to perform the check periodically.
• Do not try to replace the O-ring by yourself.
• We recommend to perform the check periodically.
PT-048_EN.book Page 27 Friday, December 11, 2009 4:37 PM