Renesas rl78 User Manual
RL78/G1A
CHAPTER 12 SERIAL ARRAY UNIT
R01UH0305EJ0200 Rev.2.00
485
Jul 04, 2013
12.5.6 Slave transmission/reception
Slave transmission/reception is that the RL78 microcontroller transmits/receives data to/from another device in the state
of a transfer clock being input from another device.
3-Wire Serial I/O
CSI00
CSI01
CSI10
CSI11
CSI20
CSI21
Target channel
Channel 0 of
SAU0
Channel 1 of
SAU0
Channel 2 of
SAU0
Channel 3 of
SAU0
Channel 0 of
SAU1
Channel 1 of
SAU1
Pins used
SCK00, SI00,
SO00
SCK01, SI01,
SO01
SCK10, SI10,
SO10
SCK11, SI11,
SO11
SCK20, SI20,
SO20
SCK21, SI21,
SO21
INTCSI00 INTCSI01 INTCSI10 INTCSI11 INTCSI20 INTCSI21
Interrupt
Transfer end interrupt (in single-transfer mode) or buffer empty interrupt (in continuous transfer mode)
can be selected.
Error detection flag
Overrun error detection flag (OVFmn) only
Transfer data length
7 or 8 bits
Transfer rate
Max. f
MCK
/6 [MHz]
Notes 1, 2
.
Data phase
Selectable by the DAPmn bit of the SCRmn register
• DAPmn = 0: Data I/O starts from the start of the operation of the serial clock.
• DAPmn = 1: Data I/O starts half a clock before the start of the serial clock operation.
• DAPmn = 0: Data I/O starts from the start of the operation of the serial clock.
• DAPmn = 1: Data I/O starts half a clock before the start of the serial clock operation.
Clock phase
Selectable by the CKPmn bit of the SCRmn register
• CKPmn = 0: Non-reverse
• CKPmn = 1: Reverse
• CKPmn = 0: Non-reverse
• CKPmn = 1: Reverse
Data direction
MSB or LSB first
Notes 1. Because the external serial clock input to the SCK00, SCK01, SCK10, SCK11, SCK20, and SCK21 pins is
sampled internally and used, the fastest transfer rate is f
MCK
/6 [MHz].
2. Use this operation within a range that satisfies the conditions above and the peripheral functions
characteristic in the electrical specifications (see CHAPTER 29 ELECTRICAL SPECIFICATIONS (T
A
=
−40
to +85
°C), CHAPTER 30 ELECTRICAL SPECIFICATIONS (G: INDUSTRIAL APPLICATIONS T
A
=
−40 to
+105
°C)).
Remarks 1. f
MCK
: Operation clock frequency of target channel
2. m: Unit number (m = 0, 1), n: Channel number (n = 0 to 3), mn = 00 to 03, 10, 11
<R>