Renesas rl78 User Manual
RL78/G1A
CHAPTER 12 SERIAL ARRAY UNIT
R01UH0305EJ0200 Rev.2.00
527
Jul 04, 2013
(3) SNOOZE mode operation (EOCm1 = 1, SSECm = 1: error interrupt (INTSRE0) generation stop)
Because EOCmn = 1, SSECm = 1, an error interrupt (INTSRE0) is not generated when a communication error
occurs.
Figure 12-92. Timing Chart of SNOOZE Mode Operation (Abnormal Operation <2>)
L
<1>
<2>
<3>
<5> <6>
<7>
<6>
<9>
<4>
P
P
SP
SP
ST
<7>,
<8>
<8>
<5>
ST
SS01
SE01
SWC0
SSEC0
SDR01
INTSR0
INTSRE0
TSF01
ST01
RxD0 pin
<10>
<11>
CPU operation status
Normal operation STOP mode
SNOOZE mode
STOP mode
SNOOZE mode
Normal operation
Receive data 1
Receive data 2
Receive data 2
Receive data 1
Shift operation
Shift operation
Data reception
Data reception
Shift
register 01
Clock request signal
(internal signal)
Read
Note 1
EOC01
<11>
<11>
Note
Read the received data when SWCm = 1.
Cautions 1. Before switching to the SNOOZE mode or after reception operation in the SNOOZE mode
finishes, set the STm1 bit to 1 (clear the SEm1 bit, and stop the operation).
And after completion the receive operation, also clearing SWCm bit to 0 (SNOOZE mode
release).
2. If the SSECm bit is 1, the PEFm1, FEFm1, and OVFm1 flags are not set when a parity error,
framing error, or overrun error occurs and no error interrupt (INTSREq) is generated.
Therefore, when the setting of SSECm = 1 is made, clear the PEFm1, FEFm1, or OVFm1 flag
before setting the SWCm bit to 1 and read the value in SDRm1[7:0] (RxDq register) (8 bits) or
SDRm1[8:0] (9 bits).
Remarks 1. <1> to <9> in the figure correspond to <1> to <9> in Figure 12-93 Flowchart of SNOOZE Mode
Operation (EOCm1 = 1, SSECm = 1).
2.
m = 0; q = 0
<R>