Renesas rl78 User Manual
RL78/G1A
CHAPTER 30 ELECTRICAL SPECIFICATIONS (G: INDUSTRIAL APPLICATIONS T
A
=
−40 to +105°C)
R01UH0305EJ0200 Rev.2.00
918
Jul 04, 2013
Notes 1. Total current flowing into V
DD
and EV
DD0
, including the input leakage current flowing when the level of the input
pin is fixed to V
DD
, EV
DD0
or V
SS
, EV
SS0
. The values below the MAX. column include the peripheral operation
current. However, not including the current flowing into the A/D converter, LVD circuit, I/O port, on-chip pull-
up/pull-down resistors, and data flash rewriting.
2. During HALT instruction execution by flash memory.
3. When high-speed on-chip oscillator and subsystem clock are stopped.
4. When high-speed system clock and subsystem clock are stopped.
5. When high-speed on-chip oscillator and high-speed system clock are stopped. When RTCLPC = 1 and setting
ultra-low current consumption (AMPHS1 = 1). Including the current flowing into the RTC. However, not
including the current flowing into the 12-bit interval timer, and watchdog timer.
6. When subsystem clock is stopped. Not including the current flowing into the RTC, 12-bit interval timer,
watchdog timer.
7. Relationship between operation voltage width, operation frequency of CPU and operation mode is as below.
HS (high-speed main) mode: 2.7 V
≤ V
DD
≤ 3.6 V@1 MHz to 32 MHz
2.4
V
≤ V
DD
≤ 3.6 V@1 MHz to 16 MHz
8. Regarding the value for current to operate the subsystem clock in STOP mode, refer to that in HALT mode.
Remarks 1. f
MX
: High-speed system clock frequency (X1 clock oscillation frequency or external main system clock
frequency)
2. f
IH
:
High-speed on-chip oscillator clock frequency
3. f
SUB
: Subsystem clock frequency (XT1 clock oscillation frequency)
4. Except subsystem clock operation and STOP mode, temperature condition of the TYP. value is T
A
= 25
°C