Guardian Technologies DVST User Manual
12
Alarms & Events
12.1
Purpose & intended use
Alarm devices connected to DVST transmission products are intended to allow
verification and response to remote events.
verification and response to remote events.
12.2
Alarm Connections
Alarm connections are made via a 37 pin D type male connector which plugs into the
side panel of the DFT0150.
side panel of the DFT0150.
WARNING: The alarm outputs are light duty reed relay types and should not be used for switching
heavy loads.
12.3
ALARM Settings
ASYS=
Set alarm system ON or OFF
(default, OFF)
(default, OFF)
The alarm system is dormant until activated by the ASYS=ON
command.
command.
When an alarm condition is detected the DVST transmitter dials stored
number TEL0 from the dial menu. If a connection cannot be made to
this number the unit dials stored number TEL1 from the dial menu. The
transmitter will continue calling until a connection is made and the
alarm is acknowledged from the receiver.
number TEL0 from the dial menu. If a connection cannot be made to
this number the unit dials stored number TEL1 from the dial menu. The
transmitter will continue calling until a connection is made and the
alarm is acknowledged from the receiver.
AON=n
AOFF=n
AOFF=n
Enable alarm contact n
Disable alarm contact n
(default, all alarm contacts enabled)
Disable alarm contact n
(default, all alarm contacts enabled)
By default all contacts are ON, or able to respond to contact closures
on the alarm input.
on the alarm input.
Alarm inputs that are not used should be set to off.
Dedicated Micros Ltd
Page 49
DVST Installation Guide
Alarms & Events