DMP Electronics Command Processor Panel User Manual

22

2841 E. Industrial Drive  Springfield, MO  65802-6310  800-641-4282

The following examples are the actual event codes a central station would receive. The full report would also include
the account number and checksum.

1A

A Fire alarm is being reported on zone 10

2B

An Ambush alarm is being reported

FB

A battery trouble is being reported

F9

A Trouble is being reported on zone nine

The DMP 4-2 format communicates to the central station as 4-2 with a checksum at 40 pulses per second (pps). The
XR10 panel using 4-2 communication will accept either a 1400Hz or 2300Hz acknowledgment tone (handshake) from
the receiver.

A report format sent to the receiver is defined as follows:

1234

56

7

aaaa

f s

c

a =

account number

f

=

first digit

s =

second digit

c =

checksum

The following example shows individual page display components:

Pager Display -

00128 = account number

2 = Message ID

0 = Always zero

010 = Zone or area number

1 = Zone Alarm

2 = Zone Trouble

3 = Areas Arming

4 = Areas Disarming

6 = User Checkin

The examples below show a typical display for each of the pager report options:

00128–10003

00128–20010

00128–30123

00128–40123

00128–60008

Only one pager signal is sent to the pager terminal equipment at a time. For each pager message to be sent, the
panel dials the first phone number and follows the steps detailed in the sections 3.19 and 3.20.

2841 E. Industrial Drive   Springfield, MO 65802-6310   800-641-4282