Pelco 100 Series User Manual

6

C2460M-A (7/03)

Figure 3.  Installation on a 4S Electrical Box

8-32 X .750 FLAT HEAD

SCREW (SUPPLIED)

8-32 X .375 PAN HEAD

SCREW (SUPPLIED)

WALL OR

CEILING

ADAPTER PLATE

BASE

4S ELECTRICAL

BOX

Refer to Figure 2 for the following steps.

1. Attach the base to the wall or ceiling (hardware not supplied).

2. Do one of the following:

Not Using Side Conduit Opening - Verify the set screw and side conduit cover are tight.

Using Side Conduit Opening - Loosen the set screw and remove the conduit plug. Install a
3/4-inch (1.91 cm) conduit fitting and tighten the set screw.

3. Connect the video cable.

Figure 2.  Installation Directly to a Concrete Wall/Ceiling

Refer to Figure 3 for the following steps. The installation instructions assume that the 4S electrical
box was previously installed.

1. Attach the ICS100-AP adapter plate (not supplied) to the 4S box with the two 8-32 x .750-inch

flat head screws supplied.

2. Pull video and power wires into the base, and attach the base to the adapter plate with the

three 8-32 x .375-inch pan head screws supplied.

3. Connect the video cable.

CONDUIT PLUG

CONCRETE WALL

OR CEILING

MOUNTING

HARDWARE

(NOT SUPPLIED)

BASE

SET SCREW