Panasonic AW-HE120 User Manual

76

   Host auth.

<Initial setting: Off>
Host authorization is set to “On” or “Off” here.



 Select the “Off” setting for no host authentication 

when the AW-RP50 remote camera controller is 
connected in a network.

   IP address

<Initial setting: blank>
The IP address of the PC from which access to the 
camera is allowed is input here.
The host name cannot be input as the IP address.



 When the “IP address/subnet mask length” is input, the 

PCs which are allowed to access the camera can be 
restricted on a subnet by subnet basis.
If, for instance, “192.168.0.1/24” has been input and 
the “2. Camera control” setting has been selected as 
the access level setting, the PCs from “192.168.0.1” to 
“192.168.0.254” will be able to access the camera at 
the “2. Camera control” access level.



 When an already registered IP address is input and 

the Set button is clicked, the host information will be 
overwritten.

   Access level

<Initial setting: 2. Camera control>
Select one of the following settings as the host access 
level.

1. Administrator

2. Camera control

For details on the access level, refer to page 75.

   Host check

A pull-down menu can be opened here, and the IP 
addresses of the registered hosts checked.
A host is indicated in the form of “Registered IP address 
[Access level]”.
(Example: 192.168.0.21 [1])
To delete a registered host (IP address), select the host to 
be deleted, and click the Delete button on the right.