Panasonic AW-HE120WE User Manual
21
Adjustment
Preset memories
(continued)
When the AW-RP555 is connected:
Up to 10 settings can be registered and called.
The [1] to [10] buttons of [PRESET] correspond to the unit’s
preset memories No.1 to No.10.
The [1] to [10] buttons of [PRESET] correspond to the unit’s
preset memories No.1 to No.10.
Registering the settings in the preset memories
1
Display the picture to be shot on the monitor.
Operate the [PAN/TILT] lever and [ZOOM] lever to
determine the camera angle.
Adjust the focus, iris, gain and white balance if they need
to be adjusted.
determine the camera angle.
Adjust the focus, iris, gain and white balance if they need
to be adjusted.
2
Hold down the [MEMORY] button.
The buttons among the [1] to [10] buttons of [PRESET]
in which settings can be registered now start blinking in
sequence.
in which settings can be registered now start blinking in
sequence.
3
With the [MEMORY] button still held down,
press the button of the preset memory number
in which the setting is to be registered.
press the button of the preset memory number
in which the setting is to be registered.
Calling the settings of the preset memories
1
Press the button among the [1] to [10] buttons
of [PRESET] in which the desired setting was
registered.
of [PRESET] in which the desired setting was
registered.
Erasing preset memory settings
1
While holding down the [MEMORY] button,
press the [OP] button.
press the [OP] button.
The [OP] button lamp blinks, and the standby status is
established.
established.
2
Press the [OP] button to establish the setting
mode.
mode.
The [PRESET] [1] to [10] button lamps blink in sequence.
When the [ZOOM] lever, [PAN/TILT] lever or [FOCUS]
lever is now operated, the mode is forcibly exited.
When the [ZOOM] lever, [PAN/TILT] lever or [FOCUS]
lever is now operated, the mode is forcibly exited.
3
Press the [PRESET] button corresponding to
the preset memory which is to be deleted.
the preset memory which is to be deleted.
When the AW-RP50 is connected:
Up to 100 settings can be registered and called.
For details, refer to the Operating Instructions of the
controller.
For details, refer to the Operating Instructions of the
controller.