Panasonic AW-HE120WE User Manual

Page of 100
7
Shooting
 How to turn the power on and off
 Turning the power on
When performing the operations 
using the wireless remote control
Set all the power switches of the units and 
devices connected in the system to ON.
 This unit does not have a power switch.
When power is supplied to it, the status display lamp 
will light up orange, and the unit is set to the standby 
mode.
Press one of the [CAM1] to [CAM4] buttons on 
the wireless remote control to select the unit.
Press the [ON/STANDBY] button on the 
wireless remote control for 2 seconds.
The POWER ON mode is established, images are 
output, and control can be exercised.
 The unit’s status display lamp now lights up green.
 It takes maximum 30 seconds per unit for the initial 
settings operation to be completed. 
During this period, the unit cannot be operated.
(Status display lamp: light up orange)
 When operation is transferred to the STANDBY 
mode: The current zoom, focus and iris positions 
are stored in the memory (POWER ON preset).
 When operation is transferred to the POWER ON 
mode: The zoom, focus and iris are adjusted to 
the positions which were stored in the memory 
(POWER ON preset) when operation was 
transferred to the STANDBY mode.
Notes
If a multiple number of units are going to be 
used, repeat steps 
2
 and 
3
 as required.
The unit’s status display lamp blinks green when a signal 
matched by the remote control ID has been received, and 
it blinks orange when a signal that is not matched by the 
remote control ID has been received.
When performing the operations using the controller
When the AW-RP655 or AW-RP555 is connected:
Set all the power switches of the units and 
devices connected in the system to ON.
 This unit does not have a power switch.
When power is supplied to it, the status display lamp 
will light up orange, and the unit is set to the standby 
mode.
Set the [OPERATE] switch on the controller to 
ON.
The POWER ON mode is established, images are 
output, and control can be exercised.
 The unit’s status display lamp now lights up green.
 It takes maximum 30 seconds per unit for the initial 
settings operation to be completed. 
During this period, the unit cannot be operated.
(Status display lamp: light up orange)
 When operation is transferred to the STANDBY 
mode: The current zoom, focus and iris positions 
are stored in the memory (POWER ON preset).
 When operation is transferred to the POWER ON 
mode: The zoom, focus and iris are adjusted to 
the positions which were stored in the memory 
(POWER ON preset) when operation was 
transferred to the STANDBY mode.
Notes
Before setting the [OPERATE] switch on the controller to ON, 
be absolutely sure to set all the power switches of the units 
and devices connected in the system to ON.
For further details, refer to the Operating Instructions of the 
controller.
When the AW-RP50 is connected:
Refer to the Operating Instructions of the controller.