Panasonic AWHE50SN User Manual

47

w

wOther 2/2 screen

“Enable” or “Disable” is set here for the function which 
turns on or turns off the tally lamp using the tally control 
signal.

This is used to enable or disable the function for clearing 
the OSD menu displays when the tally signal is received 
by a command or contact.
When the tally signal is released, the original OSD menu 
displays are restored.

“On” or “Off” is set here for the status display which 
appears during AWB operations.

“Enable” or “Disable” is set here for operations conducted 
from the wireless remote control.
The operations are enabled when the unit’s power is 
turned on from an external device other than a wireless 
remote control, and they are disabled when the power is 
turned on from a wireless remote control.

p   At the point when this item’s setting is changed, the 

new setting is not reflected in operation. 
It is reflected when the unit is set to the standby mode 
and its power is turned on.

Follow one of the procedures below if the item’s setting 
is changed by mistake and the unit can no longer be 
operated from a wireless remote control.

p   When menu operations can be performed using 

   First change the item using a control device capable 

of performing menu operations, and then turn off the 
unit’s power and turn it back on.

p   When menu operations cannot be performed using 

  1.   Turn off the power of the units and devices that are 

connected.

  2.   Disconnect the unit’s power cable, and plug it back 

in.

  3.   Perform the operation for turning on the unit’s 

power from the wireless remote control.

  4.   After changing this item, turn off the unit’s power 

and turn it back on.

Use this to return to the previous menu.