SVAT Electronics CLEARVU2 User Manual

now you can see

1.   The power adapter comes in two pieces. Assemble the power  

 

adapter by plugging the power cord into the power brick, as  

 

shown on the diagram on the previous page. Plug the three  

 

pronged power cord into a power outlet. (It is strongly 

 

recommended to use a surge protected power bar and 

 

Uninterrupted Power Supply (UPS) backup. This will prevent  

 

power surges or outages which may cause damage to the DVR or hard drive.) Plug the opposite end of the cord  

 

into the DC IN port on the back of the DVR. (Please refer to the diagram on the opposite page)

1.  The DVR will automatically display all four camera views in Quad Screen.  To view each camera individually, use    

 

the 

▲/1,◄/2, ▼/3, ►/4 buttons to view cameras 1-4 in full screen. Press the same buttons again to return to   

 

full screen.

2.  To stop or start recording, press the 

  button.

3.  While recording, you must press the 

  button first before playing back footage or entering the 

 

setup menu.

4.  While in live view (not recording), press the 

 button to enter playback mode.

5.  While in live view (not recording), press the  

 button to enter the setup menu. If the DVR password is  

 

 

enabled, a password screen will appear. Use the channel buttons (1-4) to enter the password.  The default  

 

 

password is (111111).

2.   To turn the DVR on and off, use the power switch on your UPS or power bar.  This DVR does not have a  

3.   The DVR will power on and you will see a boot screen. After the DVR initializes, your cameras should be displayed   

 

and recording will begin immediately. If you want the DVR to record continuously (24hr recording), no further    

 

setup is required. However,  you may wish to adjust the system time if it is incorrect (see page 11 System  

 

 

Setup>Time Setup for more details).