SVAT Electronics 2CV500 - 4CH User Manual

• 

The camera should be installed between 8 and 13ft above the area to be monitored

• 

Ensure there are no obstructions in the camera’s view, to maximize viewing area

• 

Ensure that the sunshade is positioned to avoid glare and position camera away from direct sunlight or indoor lighting

• 

Decide whether the camera will be wall-mounted, ceiling mounted or sit on a desk/table top. If you are mounting the camera on a wall or 
ceiling, use the mounting hardware in the package. We recommend that the mounting bracket is secured using the included screws for all 

installations

• 

This camera comes with 60ft of video/power wire. Please make sure that you mount the cameras no more than 60ft from the TV/monitor/ 
VCR/DVR. If longer wiring distance is required, 60 ft extensions can be purchased (CVW62) from your local reseller or at    

 

www.SVAT.com

• 

We recommend using a surge protected power bar to protect the cameras internal circuitry

1.  Decide if the camera will be wall-mounted or sit on a desk/tabletop. The camera can be 

adjusted for either mounting scenario by rotating it to the required position.

2.  Screw the mounting bracket into the camera’s mounting hole, turning it clockwise.
3.  Mount the camera in the desired location no more than 60 ft from the DVR unless you 

have purchased additional wiring. You may wall, ceiling or desk mount these cameras.

4.  Adjust cameras to the desired viewing angles.

3.  Plug the camera’s 

power adapter into an 
AC outlet.

 

4.  Attach the BNC to 

RCA connectors to 

one of the video 

inputs on the back 

of the DVR.

1.  Plug the 4 PIN DIN 

female connection on 

the camera into the 

 

4 PIN DIN male 

connection on the 60ft 

video/power wire. 

2.  Plug the included four 

port power supply  

into the camera power 

adapter then into the 

red power jack located 

on the 60 ft video/

power wire.