SVAT Electronics 2CV500 - 4CH User Manual
21
CV500 - 4CH
TO SET MOTION DETECTION
1. Select the camera you wish to configure the motion detection for.
2. Use the mouse wheel, or the directional arrow buttons to toggle between on and off.
2. Use the mouse wheel, or the directional arrow buttons to toggle between on and off.
MOTION DETECT
Motion detection can be set to ON or OFF. When set to ON, the DVR will recognize and perform specific activities when motion is detected based on
your settings.
your settings.
BUZZER
The Buzzer can be set to ON or OFF. When set to ON, an audible beep will be heard when motion is detected in this particular camera’s field of view.
Please refer to the BUZZER TIME SETUP in the ALARM SETUP section for more buzzer settings.
Please refer to the BUZZER TIME SETUP in the ALARM SETUP section for more buzzer settings.
SENSITIVITY
Determines how sensitive the motion detection is. Use the mouse wheel or arrow keys to change the sensitivity value from 1 (least sensitive) to 100
(most sensitive).
(most sensitive).
MAIN MENU...continued
MOTION AREA (Motion Area Masking)
You can configure each camera so that there are certain areas to detect and other areas to ignore where motion is detected.
For example, if you are monitoring your home, and there is a fan in the room, you can set the motion area to detect motion everywhere but where the fan is. This way
motion detection will not accidentally be triggered and record insignificant movement.
Motion area is also helpful if you are monitoring outside near a street where there is a lot of traffic driving by. You can set your DVR to not detect motion in the area
where the traffic is but only when a vehicle turns into the driveway.
motion detection will not accidentally be triggered and record insignificant movement.
Motion area is also helpful if you are monitoring outside near a street where there is a lot of traffic driving by. You can set your DVR to not detect motion in the area
where the traffic is but only when a vehicle turns into the driveway.
To Setup a Motion Area:
1. Choose which camera you wish to setup by using the mouse wheel or directional arrows.
2. Select
2. Select
for Motion Area.
By default the entire grid (30 x 24) is set to detect motion. Here you choose whether to select the motion detection area or to clear a section of the
grid to not detect motion. Sections of the grid that are shaded green will not trigger motion detection.
grid to not detect motion. Sections of the grid that are shaded green will not trigger motion detection.
There are three Menu options while in the grid view which can be accessed by either right clicking the mouse or pressing the Menu button.
1. Select: Used to select areas you wish to
trigger motion detection.
2. Clear: Used to mask off certain areas you
do not want to trigger motion detection.
3. EXIT: Saves changes and exits the
MOTION DETECTION SETUP MENU.
trigger motion detection.
2. Clear: Used to mask off certain areas you
do not want to trigger motion detection.
3. EXIT: Saves changes and exits the
MOTION DETECTION SETUP MENU.
The squared off area shows
the area with no detection
(would be shaded green)