Skylink HA-318T Leaflet

In order for the sensor to communicate with the receiver properly, the
sensor’s code must match with the receiver’s code.  Code  connectors 1
to 6 can be found by opening the battery cover and back cover of the
receiver.  User is required to set these code connectors randomly and
the code settings on both sensor and receiver must be the same.  Each
position of the code connector can be set to “+”, “-‘ or “0” positions.
Refer to the diagram below to set the code connectors properly.

Each receiver can work with up to 4 different sensors (to represent 4
different zones on the receiver). There are 2 connectors that determine
the zone number 1, 2, 3 and 4.  These 2 connectors can be found by
opening the battery cover.  Please follow table 1 to set the zone.

After setting up all the connectors properly,
the sensor is now ready to be powered up.

Insert a 9V alkaline battery (not included) to
the motion sensor and its LED will be on for
2 seconds. The receiver will beep and red
LED flash. The sensor requires a warm up
time of approx. 45 seconds before it can
function properly. After powering up the
sensor, face it to the wall where no motion
will be detected. After 45 seconds, the
sensor is ready. Wave your hand in front
of the sensor, the receiver will beep and
red LED will flash for approx. 15 seconds.

The Indoor/Outdoor Motion Sensor is designed to
monitor movement around your house.  The motion
sensor can be placed either indoor or outdoor.
Once motion is detected, the receiver will beep &
flash.

In this package, you should find an Indoor/Outdoor
Motion Sensor, ball-head joint, screws and a clip.

Please follow the instructions below to setup your
motion sensor.

“+” in the table means the connector for that position should be placed on
the posts.
“-“ in the table means the connector for that position should be removed.

A

B

Zone 1

+

+

Zone 2

+

-

Zone 3

-

+

Zone 4

-

-

The sensitivity of the motion sensor is adjustable. Change the setting by
placing the connector on either the ”High” or “Low” position. When the
sensitivity is set to “Low”, more movement is required to trigger the
sensor. It is recommended to set the sensitivity to “Low” and perform a
“Walk Test” (Described in Section 3 -
“Walk Test”). If the walk test result is
satisfied, the sensitivity does not
require to be adjusted further. If the
walk test result shows the sensitivity
is too low, then you can change the
sensitivity setting to “High”. Please
perform the walk test after changing
the sensitivity setting.

A ball-head joint is necessary to mount the sensor at a desire location. A height of
5-6 ft is recommended, depending on your application. Once a location is selected,
mount the ball-head joint to this location by screws provided, (see diagram 1). Once
the ball-head joint is mounted to the wall, slide the back of the sensor into the ball-
head joint (see diagram 2).
The mounting angle
can be adjusted. Please
refer to Section 3 “Walk
Test” to determine the
best mounting angle.