Sony BRCSDP12 User Manual
2
© 2003 by Sony Corporation
10/13/04
CHART A WIRING COLOR CODE
POWER AND CONTROL INPUTS
1 Camera Power (12 VDC) Red
2 Camera Power (12 VDC) Orange
3 Heater & Blower Power (24 VAC) Yellow
4 Heater & Blower Power (24 VAC) Green
2 Camera Power (12 VDC) Orange
3 Heater & Blower Power (24 VAC) Yellow
4 Heater & Blower Power (24 VAC) Green
1 Alarm 1 Blue
2 Alarm 2 Violet
3 Alarm 3 Gray
4 Common White
2 Alarm 2 Violet
3 Alarm 3 Gray
4 Common White
POWER
OPTIONAL
CHART B POWER AND CONTROL OUTPUTS
OPTIONAL
1 Alarm 1 Blue
2 Alarm 2 Violet
3 Alarm 3 Gray
4 Common White
2 Alarm 2 Violet
3 Alarm 3 Gray
4 Common White
CAMERA POWER
Connect the power plug to the camera per Sony SNCRZ30N
instructions.
instructions.
WIRING
NOTE: Failure to provide power to heater and blower will
void the warranties on both the housing and camera.
void the warranties on both the housing and camera.
22
20
18
16
14
12
10
Total vA
consumed
Wire Gauge
24k VAC Wiring Distances
The following are the recommended maximum distances for 24 VAC
with a 10% voltage drop (10% is generally the maximum allowable
voltage drop for AC powered devices).
with a 10% voltage drop (10% is generally the maximum allowable
voltage drop for AC powered devices).
35
56
90
143
228
362
576
50
1 Camera Power (12 VDC) Red
2 Camera Power (12 VDC) Orange
2 Camera Power (12 VDC) Orange
INSTALLING THE CAMERA
1
Install the Sony BRC300 pan/tilt onto the quick release
bracket using the (4) screws provided with the camera
(Figure 4).
(Figure 4).
Figure 4
2
Place the Sony BRC300 pan/tilt and quick release bracket
in the housing, sliding the three open screw slots over the
screws in the housing. Slide the bracket forward, then tighten
the captive screw on the bracket (Figures 5, 6, and 7).
screws in the housing. Slide the bracket forward, then tighten
the captive screw on the bracket (Figures 5, 6, and 7).
Figure 5
Figure 6
Figure 7