Vista -10SE User Manual
2–1
S E C T I O N 2
Installing the Control
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
♦
Mounting the Cabinet
♦
Installing the Lock
♦
Mounting the Control's Circuit Board Alone in
the Cabinet
the Cabinet
♦
Mounting the Control and RF Receiver Circuit
Board in the Cabinet
Board in the Cabinet
♦
Standard Phone Line Connections
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Mounting the Cabinet
Mount the control cabinet to a sturdy wall using fasteners or anchors (not supplied), in a
clean, dry area that is not readily accessible to the general public. Four mounting holes are
provided at the back of the cabinet for this purpose.
clean, dry area that is not readily accessible to the general public. Four mounting holes are
provided at the back of the cabinet for this purpose.
If an RF receiver is being used and you intend to mount its PC board within the cabinet, note
the following:
the following:
•
Do not mount the cabinet on or near metal objects. This will decrease RF range and/or
block RF transmissions from wireless transmitters.
block RF transmissions from wireless transmitters.
•
Do not locate the cabinet in an area of high RF interference (revealed by frequent or pro-
longed lighting of the LED in the receiver after it is operational). Random flicker is OK.
longed lighting of the LED in the receiver after it is operational). Random flicker is OK.
Installing the Lock
Use an ADEMCO No. N6277 Cam Lock and No. N6277–1 Push-On Clip (Retainer Clip).
NOTE: The cabinet can be closed and secured without a lock by using 2 screws in the cover's
edge.
1.
Remove the cabinet door. It is easily
removable for servicing and is easily
re-installed.
removable for servicing and is easily
re-installed.
2.
Remove the lock knockout from the
control cabinet door. Insert the key
into the lock. Position the lock in the
hole, making certain that the latch
will make contact with the latch
bracket when the door is closed.
control cabinet door. Insert the key
into the lock. Position the lock in the
hole, making certain that the latch
will make contact with the latch
bracket when the door is closed.
3.
Hold the lock steady, and insert the
retainer clip into the retainer slots.
Position the clip as illustrated in
order to permit easy removal.
retainer clip into the retainer slots.
Position the clip as illustrated in
order to permit easy removal.
CABINET DOOR BOTTOM
RETAINER
CLIP
CLIP
RETAINER CLIP
(NOTE POSITION)
(NOTE POSITION)
RETAINER
SLOTS
SLOTS
LOCKED
UNLOCKED
V10SE-002-V0
Figure 1. Installing the Lock
Before installing the cabinet's contents, remove the metal cabinet knockouts required for wiring
entry. Do not attempt to remove the knockouts after the circuit board has been installed.
entry. Do not attempt to remove the knockouts after the circuit board has been installed.