Avaya 03-300430 User Manual

1

ABRT

During testing of the primary information channel, system resources may 
not have been available or the port was busy during the test.

1. Check the port status.

2. Use display port location to determine the station extension of 

the port. Use status station to determine the service state of the 

port. If the port is in use, wait until it is idle before retesting.

3. If the port status is idle, then retry the command at 1-minute intervals 

up to 5 times.

2

ABRT

During testing of DTDM, system resources may not have been available or 
he port was busy during the test.

1. Check if port is being used. If possible, disconnect by toggling the 

disconnect button on DTDM. Retry the command after 1 minute.

CAUTION:

This action drops the call in progress.

1000

ABRT

System resources required to run this test are not available. The port may 
be busy with a valid call.

1. Use display port location to determine the station extension or 

attendant number of the port. Use status station or status 
attendant to determine the service state of the port. If the port is in 

use, wait until it is idle before retesting. Attendants are always in use 
(off-hook) if the handset is plugged in and the port is not busied out.

2. If the port status is idle, then retry the command at 1-minute intervals 

up to 5 times.

1001

ABRT

System resources required to run this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

1002

ABRT

The system could not allocate time slots for the test. The system is under 
heavy traffic conditions or has time slots out of service due to TDM-BUS 
errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic, 

repeat test at 1-minute intervals up to 5 times.

 1 of 2