Avaya 03-300430 User Manual

This test queries the hardware for the state of the Emergency Transfer switch and reports the 
result. If the switch is in a position where the system software can control Emergency Transfer, 
then the test passes. If the switch is in a position where the system software cannot control 
Emergency Transfer, then the test fails. The Processor controls Emergency Transfer. The 
system software does not have control of Emergency Transfer within a cabinet if the switch is in 
the manual ON or manual OFF state.

1000

ABRT

System resources required to run this test are not available.

1. Retry the command at 1-minute intervals a maximum of 5 times.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals a maximum of 5 times.

2. If the test continues to ABRT with error code 2000, check for system 

powering problems with the A carrier. Resolve all CABINET alarms. 
Then, repeat the test.

2029

ABRT

Internal system error

1. Retry the command at 1-minute intervals a maximum of 5 times.

1

FAIL

Emergency Transfer is manually turned OFF via the Emergency Transfer 
switch.

1. Place the switch in the AUTO position.

2

FAIL

Emergency Transfer is manually turned ON via the Emergency Transfer 
switch.

1. Place the switch in the AUTO position.

PASS

The system software has control of Emergency Transfer. If Emergency 

Transfer is invoked, then there can be a Major alarm in the system that is 

invoking Emergency Transfer. 

on page 1137 lists the error types and MOs that 

may cause Emergency Transfer. If any or all of these errors appear in the 

log, then refer to the appropriate Maintenance documentation and resolve 

those problems first.
If none of these errors appear in the log, then check the Emergency 

Transfer hardware.