Avaya 03-300430 User Manual

This test is non-destructive.
This test verifies if the NIC interface parameters, speed, and duplex (full/half) match with 
administration.
The test passes if the NIC parameters match administration. The test fails if the NIC parameters 
do not match administration.

1014

ABRT

Board is not inserted. Insert and administer a TN2302 board. 

1022

ABRT

Invalid board. The board is not capable of changing its ethernet options. 
The board suffix must be D or greater. 

1115

ABRT

Unable to allocate system resources (in-use) to run this test. 

1. Retry the test at one minute intervals a maximum of 3 times.

2000

ABRT

Response to the test was not received within the allowable time. Retry the 
command at 1 minute intervals a maximum of 3 times. 

1. If this result occurs repeatedly, attempt to reset the circuit pack with 

busyout board location and reset board location.

2. If this result occurs again, after resetting the board, replace the circuit 

pack. 

2012

ABRT

Internal system error.

1. Retry the command at 1-minute intervals up to 3 times. 

2100

ABRT

System resources required for this test are not available. 

1. Retry the command at 1-minute intervals up to 5 times. 

2801

ABRT

Could not find the IP address for this board. Use the change 
ip-interfaces location to administer an IP address for this board. 

Retest. 

2807

ABRT

The board is administered but not enabled on the ip-interfaces form. Use 

the change ip-interfaces location to enable the board. Retest. 

 1 of 3