Avaya 03-300430 User Manual

1003

ABRT

The system could not allocate a tone receiver for the test. The system 
may be oversized for the number of tone detectors present or some 
tone detectors may be out of service.

1. Enter display errors and follow the repair procedures for 

TTR-LEV errors in the error log. Even if there are not TTR-LEV 
errors, there may not be a tone detector available on the network 
that contains the circuit pack being tested. Verify that there is at 
least one tone detector on this network. If not, this test will always 
abort for this EI circuit pack. This will not harm the system in any 
way.

: Tone Detector circuit packs (TN768) must be of vintage 

“B” or newer. If older Tone Detector circuit packs are installed in 
the system, this test will always abort with this code.

2. Enter display errors and follow the repair procedures for 

TONE-PT errors.

3. If neither condition exists, retry the command at 1-minute intervals 

up to 3 times.

1033

ABRT

The test cannot run because either the EI board does not have a fiber 
link administered to it and there is not sufficient data to run the test, or 
there were no other PNs administered that had its EI board 
In-Service.

1. Check fiber administration to insure that there is a fiber link 

administered to this EI circuit pack.

2. If there is a fiber administered to this EI circuit pack, then some 

change in the status of the ability of the EI circuit pack in the other 
PNs to communicate with the EI or SNI circuit pack on the other 
end of its fiber has occurred.

3. Test #237 and check for EXP-INTF circuit pack Error Type 1281 in 

the Error Log for the EI circuit packs in these other PNs. If Error 
Type 1281 is present and/or Test #237 does not pass, see repair 
procedures for Test #237, in 

4. If Test #237 passes, reseat the EI circuit pack. This is not 

destructive since the circuit pack cannot be serving as the 
Expansion Archangel if it is not in service.

 2 of 5