Avaya 03-300430 User Manual

This test is nondestructive. If an EI circuit pack is a standby EI circuit pack (amber LED off) or if 
the EI is active in the PN (amber LED on), this test queries the EI circuit pack for its circuit pack 
type and vintage information. If the EI circuit pack is an active EI circuit pack in the PN (amber 
LED on long off short) the Expansion Interface Control Channel test checks to see if the EI 
circuit pack can communicate with other circuit packs in the PN using the PN TDM bus.

0

NO 

BOARD

No board was detected by the test.

1. Check the error log for wrong board (Error 125) or no board (Error 131). 

Resolve either of these issues, if applicable.

2. Check that the board is properly translated and inserted. If so, check 

for hyperactivity (Error 1538). If hyperactive, use reset board 
location.

3. Run the test again. If it fails, the ID chip on board may be bad. Replace 

the board and retest.

 6 of 6

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 3 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 3 times.

2500

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 3 times.

 1 of 2