Avaya 03-300430 User Manual

1421

ABRT

This abort code appears only when the EI circuit pack addressed in the test 
command is one that terminates a fiber link between two PNs in a direct 
connect system. It indicates that the test failed, but that this test was run on 
the PN EI board that is: a) in the same PN as the board under test b) on the 
active PNC (if duplicated) c) terminates the fiber from the PN The EI tested 
is probably not at fault.

1. Enter display alarms and follow the EXP-INTF repair procedures 

for any alarms against the PN EI that is:

a. In the same PN as the board just tested

b. On the active PNC

c. Terminates the fiber link from the PN

2. If there are no alarms logged against that EI, run Test #589 on it and 

follow procedures for this test.

3. Try this command again.

1422

ABRT

This abort code is valid and will only appear when the EI circuit pack under 
test resides in a PN of a system with a Center Stage Switch configuration. It 
means that the test failed, but that this test was then run on the PN EI on 
the same PNC as the EI under test and that test failed. This means that the 
EI originally tested is probably not at fault.

1. Resolve any alarms that are logged against the PN EI that is on the 

same PNC as the EI under test.

2. If there are no alarms logged against the PN EI, run Test #589 against 

the PN EI and follow procedures for this test.

3. Try this command again.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 3 times.

2060

ABRT

The link on the packet bus being used to perform the test has failed.

2. Retry the command at 1-minute intervals up to 3 times.

3. If the test continues to abort, enter display errors and resolve any 

PKT-INT errors.

 4 of 5