Avaya 03-300430 User Manual

140

FAIL

The Endpoint 1 SNI is physically connected to a DS1 converter but is not 
administered to be connected to a DS1 converter. Use list 
fiber-link to see a fiber link’s endpoints. Either add the DS1 converter 

complex to the fiber that this SNI is associated with:

1. Check for the fiber that this SNI is an endpoint of by checking list 

fiber-link.

2. Remove fiber-link for the fiber that this SNI is an endpoint of.
3. Add the fiber back via add fiber-link and administer the DS1 

converter complex also. Or, remove the DS1 converter connection and 
connect the SNI directly to its administered fiber endpoint by entering 
list fiber-link and verifying that the fiber-optic and metallic 

cable connections are installed as administered.

202

FAIL

The SNI circuit pack (Endpoint 2) cannot communicate with the equipped 
SNI in slot 2. Use list fiber-link to see a fiber link’s endpoints.

1. Perform the 

 in 

 in Maintenance Procedures (03-300192). This should 

resolve multiple SNI-PEER errors.

2. If the SNI being tested has SNI-PEER Error Type 1, replace the SNI 

being tested. (Replacing an SNI may be service interrupting. Refer to 
the SNI-BD section for the procedure to replace an SNI.) To view 
SNI-PEER errors, use display errors with category PNC-PEER. 

Retry the command.

3. If the SNI being tested still has SNI-PEER Error Type 1, replace the 

SNI in slot 2.

 12 of 22