Avaya 03-300430 User Manual

ABRT

Internal system error

1

ABRT

The test was aborted due to an internal system error during the switchhook 

audit.

2

ABRT

Internal system error occurred during bad scan inquiry audit.

1. Make sure that the station is not in an out of service state.

2. Retry the command at 1-minute intervals up to 5 times.

3

ABRT

This port may have been busied out by system technician.

1. Look in the Error Log for Error Type 18 (port busied out) for this port. If 

this Error Type is present, release the port via release station 
extension, and run the test again.

2. Make sure that the terminal is connected.

3. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available. The port may 
be busy with a valid call.

1. Use display port location to determine the station extension 

number of the port. Use status station to determine the service 

state of the port. If the port is in use, wait until it is idle before testing.

2. If the port status is idle, then retry the command at 1-minute intervals up 

to 5 times.

1004

ABRT

The port was seized by a valid call during the test. The test has been 
aborted.

1. Use display port location to determine the station extension 

number of the port. Use status station to determine the service 

state of the port. If the port is in use, wait until it is idle before testing.

2. Retry the command at 1-minute intervals up to 5 times.

1392

ABRT

This port is currently a TTI port and the test will not execute on it.

1. Verify that the port is a TTI port using either display port (the port is 

a TTI port) or list config (shows a t for the port).

2. If either list config or display port indicate that the port is not a 

TTI port, escalate the problem. If both commands indicate that the port 
is a TTI port, the abort is correct, and no action is necessary.

 1 of 2