Avaya 03-300430 User Manual
Communication Manager Maintenance-Object Repair Procedures
1368 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
FPGA Query
This test verifies the status of the FPGA device on the TN2302 circuit pack. If the device is bad,
software posts an error and alarm, and takes every DSP out of service (every DSP that is
controlled by the one FPGA). Software then attempts to reset the FPGA. If the reset passes or
the original test passes, the DSPs are placed back into service.
software posts an error and alarm, and takes every DSP out of service (every DSP that is
controlled by the one FPGA). Software then attempts to reset the FPGA. If the reset passes or
the original test passes, the DSPs are placed back into service.
Ethernet Query
This test passes if the TN2302 hardware tests ok and the Ethernet port is connected.
Otherwise, it fails.
Otherwise, it fails.
SCOTCH Sanity
The Scotch device on a board communicates with switch software via the TDM bus for
conferencing and gain adjustment. This is done by setting up connections on TDM bus time
slots.
There are three different errors that can be generated due to the problems with Scotch devices
on the board: NPE SCOTCH 0, NPE SCOTCH 1, and NCE SCOTCH. If any of these errors are
reported from the board, the DSPs are taken from service and a circuit pack reset is executed
by running the SAKI test.
conferencing and gain adjustment. This is done by setting up connections on TDM bus time
slots.
There are three different errors that can be generated due to the problems with Scotch devices
on the board: NPE SCOTCH 0, NPE SCOTCH 1, and NCE SCOTCH. If any of these errors are
reported from the board, the DSPs are taken from service and a circuit pack reset is executed
by running the SAKI test.
Table 481: Test #1406 MP Diagnostic Test
Error
Code
Code
Test
Result
Result
Description / Recommendation
2012
ABRT
System error:
1. Retry the command at 1-minute intervals up to 5 times.
2100
ABRT
System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL
The MP Diagnostic test has failed for this TN2302 and the board is in the
out-of-service state.
out-of-service state.
1. Enter busyout board location.
2. Enter reset board location.
3. Enter release board location.
4. Enter test board location long.
2. Enter reset board location.
3. Enter release board location.
4. Enter test board location long.
If the board continues to fail, replace the board.
1 of 3