Avaya 03-300430 User Manual

An audio channel using G.711 is setup between both boards. A 1004-Hz test tone is transmitted 
from the source PN to the destination PN over the G.711 audio channel. The test tone is then 
transmitted from the destination PN to the source PN.

1002

ABRT

The system could not allocate timeslots for the test. The system may be 
under heavy traffic conditions or it may have timeslots out of service due 
to TDM-BUS errors.

1. If system has no TDM-BUS errors and is not handling heavy traffic, 

retry the command at 1-minute intervals up to 3 times.

2. If system has TDM-BUS errors, clear any errors, and retry the 

command at 1-minute intervals up to 3 times.

3. If the command continues to abort, escalate the problem.

1003

ABRT

The system could not allocate a tone receiver for the test. The system 
may be oversized for the number of Tone Detectors present, or some 
Tone Detectors may be out of service.

1. Resolve any TTR-LEV errors. Even without TTR-LEV errors, a Tone 

Detector could be unavailable in the PN containing the circuit pack 
being tested. Verify that at least one Tone Detector resides in this 
PN. If not, this test always aborts, but does not harm the system.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the command at 1-minute intervals 

up to 3 times.

1014

ABRT

Board not inserted.

2000

ABRT

 Response to the test was not received in the allowable time period.

1. Retry the command at 1-minute intervals up to 3 times.

2012

ABRT

Generic system call failed. Internal system error.

1. Retry the command at 1-minute intervals up to 3 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 3 times.

2500

ABRT

Internal system error.

1. Retry the command at 1-minute intervals up to 3 times.

 1 of 3