Avaya 03-300430 User Manual

Page of 2574
Event Data
Issue 1 June 2005
141
 
Cause Value 16
[0x10/0x90] -
Normal call clearing/
Requested facility not implemented (1TR6: AT&T ISDN Protocol)
Cause Value 16 
indicates that the call was disconnected normally by either end hanging up.
Cause Value 16 (1TR6) indicates that the call could not be completed because the equipment 
sending this Cause Value does not support the requested service, feature, or supplementary 
service in the SETUP message. 
This Cause Value has end-to-end significance and should always be passed back through the 
network to the user.
Troubleshooting 
Check the diagnostic information (DIAG) for the facility identifier of the not implemented 
service. See 
If the remote device terminated the connection unexpectedly, contact the person 
responsible for the remote end to determine if there is a problem with the remote endpoint.
For data bearer capability calls, if the connection has failed to establish, but the CONNECT 
and CONNECT_ACK messages were exchanged before the DISCONNECT was 
received, the handshake between the devices involved in the call might have failed due to:
- Option settings with the endpoint devices
- Bandwidth constriction issues on the b-channel used by the two devices to make the call
Cause Value 17
[0x11/0x91] -
User busy/
Requested facility not subscribed (1TR6: AT&T ISDN Protocol)
Cause Value 17
 indicates that the endpoint called is unable to accept another call.
Cause Value 17 (1TR6) indicates that the call could not be completed because the user has not 
subscribed to the service, feature, or supplementary service requested in the SETUP message.
This Cause Value has end-to-end significance and should always be passed back through the 
network to the user.
See also 
Troubleshooting
Wait and try the call again later.
If the user is supposed to have access to the service, feature, or supplementary service, 
complete the ordering process with the ISDN service provider.